Test operation of yuvarlak ayırıcı

Usually some customers don’t know how to operate after receiving the machine. EVERSUN makineleri sizin için test prosedürünü açıklayacaktır.

1. Güç anahtarını kapatın, ve sonra bunun için çalıştırın 20-30 dakika herhangi bir işlem yapılmadan. Normalde, the motor should run counterclockwise. If the direction is wrong, adjust the three-phase power supply.
2. It should be confirmed that the vibration motor is running within the rated current range. At the beginning of operation, especially in low temperature occasions, the current will be slightly higher, but within 20-30 dakika, it should be reduced to the rated current value.
3. There should be no abnormal sound on the yuvarlak ayırıcı. If there is an abnormal sound, it should be quickly turned off for inspection. The abnormal sound is usually caused by loosening of the fastening components. Especially during transportation and assembly after disassembly, please pay attention to the fastening of each part. The yuvarlak ayırıcı has an instantaneous resonance zone (1-3 seconds) when it starts and stops. Şu anda, the amplitude and noise will increase significantly, which is normal.
4. After idling, a small amount of material can enter the screen through the feed port, and then slowly increase to the required tolerable feed amount. Şu anda, the weight should be adjusted according to the net surface discharge to make the efficiency of the screening machine reach the best state.

Ana ürünümüz eleme makinesidir.,Vibro elek makinesi,Ultrasonik eleme makinesi,Vakum konveyör,damping istasyon, Tumbler eleme makinesi, Industrial'in eleme makinesi, Sıvı filtresi, Dikdörtgen döner elek, Vidalı konveyör ve vb.

Herhangi bir desteğe ihtiyacınız olursa lütfen bizimle iletişime geçmekten çekinmeyin.

Satış Departmanı: Sales@vibrosievingmachine.com, Cell/WhatsApp:+86 13162301696